Kia Soul EV: Tail Gate / Tail Gate Latch Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Latch Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
1.
Remove the tail gate trim.
(Refer to Tail Gate - "Tail Gate Trim")
2.
After loosening the mounting bolts, remove the tail gate latch assembly (A).

Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

3.
Disconnect the tail gate latch connector (A).

4.
Install in the reverse order of removal.
   
Make sure that the tail gate locks/unlocks and opens/closes properly.
Adjust the tail gate alignment.
Make sure that the connectors are connected properly.
Tail Gate Latch Components and Components Location
Component Location 1. Tail gate latch assembly ...

Tail Gate Back Panel Components and Components Location
Component Location 1. Tail gate back panel ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Seat Belt Pretensioner (BPT) Description and Operation


Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupants by retracting the seat belt webbing ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Parking Assist Sensor Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the ultrasonic sensor. [Front sensor, Rear center sensor] [Rear side senso ...

Copyright © www.ksoulev.com 2020-2025