Disconnect the battery negative cable, and wait for at least thirty seconds before beginning to work.
2.
To remove the emergency fastening device (C), keep on pushing
the lock pin (A) as arrow direction. And then remove the seat belt
after pushing the lock pin (B).
3.
Remove the center pillar lower trim.
(Refer to Body - "Center pillar trim")
4.
Remove the center pillar upper trim.
(Refer to Body - "Center pillar trim")
5.
After loosening the mounting bolt, remove the front seat belt upper anchor (A).
6.
Disconnect the seat belt pretensioner connector (A).
7.
Loosen the seat belt pretensioner mounting bolt (B) and remove the seat belt pretensioner.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
Description
Emergency Fastening Device (EFD) is deployed concurrently
with the Belt Pretensioner to strongly pull down the seat belt during a
deployment condition after a collision. It is locat ...
Description
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. Engine ECU
converts the voltage value to control the cooling fan by operating it
in high speed or low speed. Engine ECU stops the operation of the
compres ...