Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
No.
Description
1
Ground (-)
2
Door (-)
3
Room/ Door (-)
4
Battery (+)
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA) and then remove the overhead console (A).
3.
Remove the overhead console after disconnecting the connectors (A).
4.
If it is necessary to replace the bulb, replace the bulb (in the following order).
(1)
Remove the overhead console lens (A).
(2)
Remove the bulb (A).
Installation
1.
Install the overhead console lamp after connecting the connector.
Inspection
1.
Check that the switch operates properly after disconnecting the room lamp connector (A).
Room Lamp
Removal
Room Lamp
1.
Disconnect the negative (-) battery terminal.
2.
De ...
Inspection
1.
The SJB can be diagnosed by using the GDS. The SJB
communicates with the GDS which then displays inputs and outputs along
with codes.
It will be able to quickly diagnose defects ...
High Voltage Shut-off Procedure
Be sure to read and follow the “General Safety Information
and Caution” before doing any work related with the high voltage
system. Failure to follow the safety instructions may result in serious
electrical injuries.
...
Description
The A/C Pressure Transducer (APT) converts the pressure value
of high pressure line into voltage value after measuring it. Engine ECU
converts the voltage value to control the cooling fan by operating it
in high speed or low speed. Engine ECU stops the operation of the
compres ...