Kia Soul EV: Lighting System / Hazard Lamp Switch Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Repair procedures

Inspection

1.	The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to quickly diagnose defects of hazard lamp switch with GDS. GDS can forcefully operate actuator, monitor input/output values and self diagnose.

2.	To diagnose the SJB function, select the vehicle model, BCM and SJB.

3.	To consult the present input/output values of SJB, select "Current DATA" to view current information of SJB input/output conditions.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the center airvent assembly (A).

3.	Disconnect the connector (A) from the center airvent assembly.

4.	Remove the hazard switch (A) from the center airvent assembly.

Installation

1.	Install the hazard switch in the center airvent assembly.

2.	Connect the connector and install the center airvent assembly.

3.	Connect the negative (-) battery terminal.

Overhead Console Lamp Repair procedures

Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. No.Description1Groun ...

Rheostat Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Description and Operation

Description System Overview The System offers the following features: – Human machine interface through a 1-stage button, for terminal switching and engine start. – Control of external relays for ACC / IGN1 / IGN2 terminal switching and STARTER, without use of mechanical i ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Front Seat Assembly Repair procedures

Replacement 1. Loosen the front seat assembly mounting bolts (A). Tightening torque : 34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft) [Front] [Rear] 2. Remove the front seat assembly (A). 3. Disconnect the airbag connector (A), seat heater & power seat switch connector (B) ...