Kia Soul EV: Lighting System / Room Lamp Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Lighting System / Room Lamp Repair procedures

Inspection
1.
Check that the switch operates properly after disconnecting the room lamp connector (A).
Room Lamp

Removal
Room Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver.

3.
Separate the room lamp (A) from the roof trim after loosening the screws (2EA).

4.
Remove the room lamp (B) after disconnecting the connector (A).

5.
If the bulb needs to be replaced, replace the bulb (A) after detaching the lamp lens.

Vanity Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the vanity lamp assembly (A).

3.
Remove the vanity lamp assembly (B) after disconnecting the connector (A).

4.
If it is necessary to replace the bulb, replace the bulb (A).

Installation
Room Lamp
1.
Install the room lamp assembly after connecting the lamp connector.
2.
Install the lens after assembling the bulb.
Vanity Lamp
1.
Install the vanity lamp assembly after connecting the lamp connector.
Turn Signal Lamp Repair procedures
Removal Door Mirror Turn Signal Lamp 1. Disconnect the negative (-) battery terminal. 2. Remove the mirror holder (A) from the outside mirror assembly. 3. Remove the door mirror cover (A) ...

Overhead Console Lamp Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. No.Description1Groun ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Repair procedures


General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. Test conditionNormal ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Power Door Lock Actuators Repair procedures


Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. (Refer to Body - "Front Door Module") 3. Disconnect the connectors from the actuator. 4. Check actuator operation by connecting power an ...

Copyright © www.ksoulev.com 2020-2023