Kia Soul EV: Keyless Entry / Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Keyless Entry / Repair procedures

Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
(Refer to Body - "Front Door Module")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

[Central Lock]

5.
Check for continuity between the terminals in each switch position according to the table.

Rear Door Lock Module Inspection
1.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
2.
Remove the rear door module.
(Refer to Body - "Rear Door Module")
3.
Disconnect the connectors from the actuator.

4.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

[Central Lock]

5.
Check for continuity between the terminals in each switch position according to the table.

Tailgate Lock Module Inspection
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Disconnect the 4P connector from the actuator.

3.
Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch
1.
Remove the tailgate trim.
(Refer to Body - "Tailgate Trim")
2.
Disconnect the connector from the actuator.

3.
Check for continuity between the terminals in each switch position according to the table.

Components and Components Location
Component Location 1. BCM & RF receiver2. Key warning switch3. Front door lock actuator & switch4. Rear door lock actuator & switch5. Tailgate open switch ...

Lighting System
...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Relay Box (Passenger Compartment) Description and Operation


Description Smart Junction Box(SJB) 1. General function : Interior Junction Box + some functions of BCM It uses CAN communication and IPS to control loads. 2. Main functions: – Low speed CAN communication (100kbps) – Self diagnosis (Lamp open/short) – Fail ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Components and Components Location


Components Location [Front Suspension] 1. Drive shaft 2. Lower arm 3. Front axle4. Front strut assembly5. Stabilizer bar 6. Steering gear box 7. Sub frame 8. Front stabilizer link [Power Electric Frame] 1. Power Electric Frame ...

Copyright © www.ksoulev.com 2020-2023