Kia Soul EV: SRSCM / Occupant Detecting Sensor (ODS) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / SRSCM / Occupant Detecting Sensor (ODS) Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front passenger seat assembly. (Refer to the Body group- Seat)

3.	Remove the seat cushion assembly. (Refer to the Body group- Seat)

Installation

1.	Install the ODS equipped seat cushion assembly. (Refer to the Body group- Seat)

2.	Install the front passenger seat assembly. (Refer to the Body group - seat)

3.	Reconnect the battery negative cable.

After installing the ODS, confirm proper system operation :

•	Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.

•	Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the ODS does not require suppression and the passenger airbag is enabled.

Occupant Detecting Sensor (ODS) Components and Components Location

Components ...

Schematic Diagrams

Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal Harness Connector Pin No.Function (Connector A)Pin No.Function (Connector B)1--1--2--2--3--3--4- -4-- ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Electric Parking Brake (EPB) Schematic Diagrams

EPB Circuit Diagram (1) EPB Circuit Diagram (2) EPB connector input/output Pin DescriptionPin Description1WC-CAN (High)21G/BCenter Fascia Switch (ElectronicParking Brake Switch (SW3))2BrC-CAN (Low)22--3--23--4--24--5--25--6--26--7--27GCenter Fascia Switch (ElectronicParking Brake ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Seat Heater (Non-Air Ventilation) Repair procedures

Inspection First Row Seat 1. Check for continuity and measure the resistance between terminals. Part?ConnectorResistance(± 10%)Cushion (C)1-24.54 ?Back (B)1-25.16 ?Set (A)1-49.70 ? Second Row Seat 1. Check for continuity and measure the resistance between terminals. [LH] [RH] Pa ...