Kia Soul EV: Hood / Hood Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Hood / Hood Assembly Repair procedures

Replacement
   
Be careful not to damage the hood and body.
   
When removing and installing the hood, work in a group of two or more.
When removing the clips, use a clip remover.
1.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).

2.
After loosening the hood hinge (B) mounting bolts, remove the hood assembly (A).

Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

3.
Install in the reverse order of removal.
   
Make sure that the hood locks/unlocks and opens/closes properly.
Adjust the hood alignment.
Hood Assembly Components and Components Location
Component Location 1. Hood assembly ...

Hood Lift Repair procedures
Replacement     • When removing and installing the hood lifter, work in a group of two or more. • When removing the clips, use a clip remover. 1. ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: High Voltage PTC Heater Repair procedures


Inspection 1. Check for output signal in the heater and A/C control unit. 2. Using the GDS, check whether there is a problem in the interlock. 3. Check whether the low voltage (12V) is supplied or not. 4. For inspection, refer to the Self Diagnosis and Fail Safe. Replacement ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Front Door Belt Inside Weatherstrip Repair procedures


Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A). 3. Install in the reverse order of removal.     • Replace any damaged clips. ...

Copyright © www.ksoulev.com 2020-2025