Adjustment
1.
After loosening the hinge (A) mounting bolt, adjust the hood (B) clearance by moving it up and down, or left and right.
2.
Adjust the hood height by turning the hood overslam bum ...
Replacement
1.
Remove the front door module.
(Refer to Front Door - "Front Door Module")
2.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.
3.
Remove the front door outside handle connector wiring harness (A).
4.
Remove the front door ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode control actuator operates to the defrost mode when 12V is connected to terminal 3 and ground to terminal 7.
Verify that the mode control actuator operates to the vent m ...