Check for continuity between the terminals while operating
the wiper and washer switch. If it is not in normal condition, replace
wiper and wiper switch.
Wiper Switch
Washer Switch
Removal
1.
Remove the steering column shroud lower / upper panel.
(Refer to Body - "Steering Column Shroud Panel")
2.
Disconnect the connector (A).
3.
If the wiper and washer switch (A) needs to be removed,
release the lock of wiper switch using a tool without the need to remove
the steering wheel and the clock spring.
4.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
5.
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
6.
Remove the multifunction switch assembly (A) after loosening 2 screws.
Installation
1.
Install the multifunction switch after connecting the connector.
Replacement
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Us ...
Inspection
Wrap tin foil around the end of the voltmeter test lead to
prevent damaging the heater line. Apply finger pressure on the tin foil,
moving the tin foil along the grid line to check for open circuits.
1.
Turn on the defogger switch and use a voltmete ...