General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and ...
Replacement
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
...
Removal
Head lamps become very hot during use; do not touch them or attach any hardware immediately after turning them off.
The head lamp bulb should not be removed from the head lamp assembly until just before installing a new bulb.
L ...
Components Location
High Voltage Battery System Assembly
1. BMS ECU2. Main Relay 3. Pre Charge Relay4. Pre Charge Resistor5. Battery Current Sensor6. Safety Plug7. Main Fuse8. Battery Temperature Sensor9. Runaway Arresting Device (RAD)10. High Voltage Battery Heater (With heater system)11. ...