Kia Soul EV: SRSCM / Seat Belt Buckle Switch (BS) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS) Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front seat assembly. (Refer to Body - "Front seat")

3.	Remove the seat belt buckle switch. (Refer to Body - "Front seat belt buckle")

Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

3.	Install the seat belt buckle switch. (Refer to Body - "Front seat belt buckle")

4.	Install the front seat assembly. (Refer to Body - "Front seat")

5.	Reconnect the battery negative cable.

After installing the seat belt buckle switch, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

Seat Belt Buckle Switch (BS) Components and Components Location

Components ...

Occupant Detecting Sensor (ODS) Description and Operation

Description In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring el ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Repair procedures

Adjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. Alignment adjustment Standard value [mm(in.)] (1) Front edge : 0 mm (0 in.) (2) Rear edge : 0 mm (0 in.) 2. Completely open ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Blower Unit Components and Components Location

Component Location 1. Blower unit Components 1. High voltage PTC heater core2. Ionizer3. Evaporator temperature sensor4. Air inlet filter cover assembly5. Heater core pipe mounting bracket6. Heater - evaporator seal7. Intake duct case [LH]8. Intake arm9. Intake actuator motor assembly10. ...