Kia Soul EV: Panorama Sunroof / Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Repair procedures

Adjustment

Inspect Glass Alignment

Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.

Alignment adjustment

Standard value [mm(in.)]

(1) Front edge : 0 mm (0 in.)

(2) Rear edge : 0 mm (0 in.)

2.	Completely open the movable glass using the panorama sunroof switch.

3.	Remove both sides of the decoration cover (A) by pulling it in the direction of the arrow.

4.	Completely close the movable glass using the panorama sunroof switch.

Adjust the height of the glass by slighty loosening the screws (A).

•	Be careful not to damage the screw.

Emergency operation

1.	Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.

2.	Use a hexagon wrench to open or close the panorama sunroof after removing the roof trim. Do not apply too much force when opening or closing the panorama sunroof. [Movable Glass Motor ] [Roller Blind Motor]

3.	If needed reset the panorama sunroof according to the reset method.

Components and Components Location

Components 1. Roof side moulding [LH]2. Roof side moulding [RH]3. Movable glass 4. Wind deflector5. Decoration cover [LH]6. Decoration cover [RH]7. Center cover8. Panorama sunroof frame assembly9 ...

Movable Glass Repair procedures

Replacement 1. Completely open the movable glass using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A) by pulling it in the direction of the arrow. 3. Comple ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Door Trim Repair procedures

Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Be ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Shock Absorber Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) • Be carefu ...