Kia Soul EV: Rear Axle Assembly / Rear Hub - Carrier Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Driveshaft and axle / Rear Axle Assembly / Rear Hub - Carrier Repair procedures

Replacement

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from rear hub.

Tightening torque:

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Loosen the guide rod bolt (B) and the remove the rear caliper body (A).

Tightening torque:

21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)

4.	Remove the pads (B), in the caliper carrier (A).

Remove the brake caliper mounting bolts (B), and then place the brake caliper assembly (A) with wire.

Tightening torque:

63.7 ~ 73.5 N.m (6.5 ~ 7.5 kgf.m, 47.0 ~ 54.2 lb-ft)

6.	Disconnect the wheel speed sensor connector (A).

Loosen the screws (B), and then remove the brake disc (A).

Tightening torque:

4.9 ~ 5.8 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)

Loosen the bolts and then remove the hub bearing (A).

Tightening torque:

49.0 ~ 58.8 N.m (5.0 ~ 6.0 kgf.m, 36.2 ~ 43.3 lb-ft)

9.	Remove the hub bearing by using the rubber hammer.

10.	Install in the reverse order of removal.

Inspection

1.	Check the hub for cracks and the splines for wear.

2.	Check the brake disc for scoring and damage.

3.	Check the rear axle carrier for cracks.

4.	Check the bearing for cracks or damage.

Installation

Install in the reverse order of removal

Use a SST (09581-11000) when installing the brake caliper assembly.

(Refer to Brake System - "Front Disc Brake")

2.	Check the front alignment. (Refer to Suspension System - "Front Alignment")

Rear Hub - Carrier Components and Components Location

Components 1. Rear dust cover2. Rear wheel hub assembly3. Rear brake disc ...

Suspension System

...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Components and Components Location

Component Location 1. Cowl top cover ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Speakers Repair procedures

Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws is removed and the wiring connector is connected precisely to remove vibration transmitted from body trims and surrounding parts. ...