Kia Soul EV: Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Inspection

Rear Wiper Motor

1.	Remove the connector from the rear wiper motor.

2.	Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.

Check that the motor operates normally. Replace the motor if it operates abnormally.

No.	Description
1	Battery (+)
2	Parking
3	Ground
4	Signal

Automatic Stop Operation Check

1.	Operate the motor at low speed using the stalk control.

2.	Stop the motor operation anywhere except at the off position by disconnecting terminal 2.

3.	Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.

4.	Check that the motor stops running at the off position.

Removal

1.	Detach the rear wiper cap (A).

2.	Remove the rear wiper arm & blade (B) after removing rear wiper HEX nut (A).

3.	Remove the rear wiper grommet (A).

4.	Remove the tailgate trim after opening the tailgate. (Refer to Body - "Tailgate Trim")

5.	Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.

Installation

Install the rear wiper motor assembly.

Tightening torque Bolt :

6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)

2.	Install the tailgate trim.

Install the rear wiper arm cap after tighting the nut.

Tightening torque Nut :

3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)

4.	Set the rear wiper blade and to the lowest defogger heat line and tailgate glass. A : Auto stop position

Components and Components Location

Component Location 1. Head cap2. Rear wiper arm nut3. Rear wiper arm & blade4. Grommet5. Rear wiper motor assembly6. Rear wiper motor bolt ...

Rear Washer Switch Repair procedures

Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear Wa ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Charge Door Opener Actuator Repair procedures

Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumper Cover") 3. Remove the charge door opener cover assembly. (Refer to Body - "Charge Door Opener Cover") 4. Remove the charge door opener actuator cable (A). 5. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Wheel Repair procedures

Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tightening torque should be checked using a torque wrench. Run out inspection 1. Jack up the ...