Other information:
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.
2.
Install in the reverse order of removal.
•
...
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminals No. 1 and No. 2.
2.
Inspect the voltage value whether it is within the specified range.
Voltage = 0.00878835 * Pressure + 0.5[PSIA]
3.
If the measured voltage value is not within t ...