Kia Soul EV: Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Removal
1.
Disconnect the battery negative cable and wait for at least thirty seconds before beginning to work.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof trim assembly")
3.
Disconnect the curtain airbag harness connector (A).

4.
After loosening the mounting bolts and nuts remove the curtain airbag.
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts and nuts.

Tightening torque
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

   
Never twist the airbag module during installation as twisted module may result in abnormal operation. (of the airbag module.)
4.
Connect the curtain airbag connector.
5.
Install the roof trim assembly.
(Refer to Body - "Roof trim assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Curtain Airbag (CAB) Module Components and Components Location
Components ...

Airbag Module Disposal Description and Operation
Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airba ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Troubleshooting


Troubleshooting Vehicle inspection SYMPTOM CHART SymptomSuspect AreaRemedy (See page)Squeak or grunt-noise from the front suspension, occurs more in cold ambient temperatures-more noticeable over rough roads or when turningFront stabilizer barUnder these conditions, the noise is acceptabl ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Front Door Window Glass Repair procedures


Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A). 3. Remove the front door window glass mounting hole plug (A). 4. Before removing the front door glass (C), loosen the mounting bolt (A) as l ...

Copyright © www.ksoulev.com 2020-2023