Kia Soul EV: High Voltage Charging System / ON-Board Charger (OBC) Schematic Diagrams

Kia Soul EV (PS EV) 2015-2020 Service Manual / EV Battery System / High Voltage Charging System / ON-Board Charger (OBC) Schematic Diagrams

Schematic Diagrams

Input Connector (AC)
Terminal
Description
Specification
Current (normal)
Voltage (maximum)
1
Phase voltage (L1)_220VAC
33A
310VAC
2
Ground
3
Phase voltage (L2)_220VAC

Output Connector (DC)
Terminal
Description
Specification
Current (normal)
Voltage (maximum)
1
High Voltage Battery (-)
25A
495VDC
2
High Voltage Battery (+)
3
High Voltage Interlock Pin
4
High Voltage Interlock Pin

Signal Connector
Terminal
Description
Specification
Current (normal)
Voltage (maximum)
1
Ground
1A
0V
2
IG3
18V
3
Connection sensing (EVSE)
5V
4
Control Pilot (EVSE)
12V
5
Relay operation
18V
6
CAN_Low
1.5-2.5V
7
CAN-High
2.5-3.5V
8
Charge state indication (Right)
18V
9
Charge state indication (Center)
18V
10
Charge state indication (Left)
18V
11
CP, PD Shielding ground
0V
12
Auxiliary 12V battery (+)
18V

ON-Board Charger (OBC) Description and Operation
Description In normal charge, the battery is charged through the On-Board Charger (OBC) using external power supply of 220V. On-Board Charger (OBC) is the equipment that charges the high voltage ...

ON-Board Charger (OBC) Repair procedures
Removal     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure t ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Repair procedures


Adjustment 1. After loosening the hinge (A) mounting bolt, adjust the hood (B) clearance by moving it up and down, or left and right. 2. Adjust the hood height by turning the hood overslam bumpers (C). 3. After loosening the hood latch (D) mounting bolts, adjust the latch by moving it up ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Parking Assist Sensor Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the ultrasonic sensor. [Front sensor, Rear center sensor] [Rear side senso ...

Copyright © www.ksoulev.com 2020-2025