Kia Soul EV: Hood / Hood Latch Release Handle Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
   
Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.
Install in the reverse order of removal.
   
Make sure that the hood latch cable is connected properly.
Make sure that the hood locks/unlocks and opens/closes properly.
Hood Latch Release Handle Components and Components Location
Component Location 1. Hood latch release handle ...

Hood Latch Components and Components Location
Component Location 1. Hood lower latch assembly ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: EPB Switch Repair procedures


Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3. Remove the EPB switch assembly. Installation 1. Install the EPB switch assembly to the floor console upper cover. 2. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Components and Components Location


Components 1. Rear bumper cover2. Rear bumper side bracket ...

Copyright © www.ksoulev.com 2020-2025