Replacement
1.
Remove the glue on both ends (A) of the hood weatherstrip (B).
•
Be careful not to scratch the hood weatherstrip.
2.
Install in the r ...
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off ...
Replacement
1.
Remove the hole plug (A).
2.
After loosening the mounting bolt, remove the front door outside handle cover (B).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
3.
Remove the front door outside handle (A) by sliding it backward.
4.
Disconnect ...