Kia Soul EV: Front Seat / Front Seat Assembly Repair procedures
1.
Loosen the front seat assembly mounting bolts (A).
Tightening torque :
34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)
[Front]
[Rear]
2.
Remove the front seat assembly (A).
3.
Disconnect the airbag connector (A), seat heater & power seat switch connector (B) and front seat belt buckle connector (C).
[Driver''s]
[Passenger''s]
4.
Install in the reverse order of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat in the rearmost position. Check that each slide is locked, and then temporarily tighten the front mounting bolts.
•
Set the seat in the foremost position. Check that each slide is locked, and then completely tighten the rear mounting bolts.
•
Set the seat in the rearmost position again and then completely tighten the front mounting bolts.
•
Check that the seat operates to and fro smoothly and that the locking portion locks properly.
Component Location
1. Front seat assembly
...
Component Location
1. Front seat shield outer cover
...
Other information:
Description
In order to make normal activation of airbag system, SRSCM
detects DTC(s) for the Passenger side Body Detection System. If the seat
is occupied, Body sensor detects how measuring electrostatic capacity
and send signal to SRSCM via CAN. SRSCM recognizes the signal as 2(two)
dif ...
Components Location
1. Flex steering swithch
...