Kia Soul EV: Interior Trim / Front Pillar Trim Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Interior Trim / Front Pillar Trim Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the front pillar trim.
(1)
Use the following tool (A) to remove the front pillar trim.

(2)
Slightly spread open the front pillar trim and then place the tool (A) on the mounting clip (B) as in the picture below.
After placing the tool (A) on the mounting clip (B), push it forward.
   
Once the front pillar trim has been removed, replace the clips to new ones.

(3)
Remove the front pillar trim (A).

How to mount front pillar trim

   
Remove the mounting clip (A) by turning it clockwise.

2.
Install in the reverse order of removal.
   
Replace any damaged clips.
Front Pillar Trim Components and Components Location
Component Location 1. Front pillar trim ...

Center Pillar Trim Components and Components Location
Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Parking Assist Sensor Repair procedures


Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front/rear bumper cover. (Refer to Body - "Front Bumper Cover") (Refer to Body - "Rear Bumper Cover") 3. Disconnect the connector (A) from the ultrasonic sensor. [Front sensor, Rear center sensor] [Rear side senso ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Torsion Beam Axle Components and Components Location


Components 1. Rear torsion beam axle ...

Copyright © www.ksoulev.com 2020-2024