Kia Soul EV: Air Conditioning System / Evaporator Temperature Sensor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Evaporator Temperature Sensor Repair procedures

Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the evaporator temperature sensor connector.
3.
Measure the resistance between terminals "1" and "2" of the evaporator temperature sensor.

4.
Connect the evaporator temperature sensor connector.
5.
Run the engine and turn the A/C switch ON, then measure the voltage between the terminals of the harness connector.
Specification
Evaporator core
temperature[°C(°F)]
Resistance[K?]
-10 / (14)
43.35
0 / (32)
27.62
10 / (50)
18.07
20 / (68)
12.11
30 / (86)
8.3
40 / (104)
5.81

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the console side cover (A).
[RH]

3.
Disconnect the evaporator temperature sensor connector (A).

4.
Remove the evaporator temperature sensor (A) by pulling it out after rotating it 90° in a counterclockwise direction.

5.
Install in the reverse order of removal.
Evaporator Temperature Sensor Description and Operation
Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling ...

In-car Sensor Description and Operation
Description The In-car air temperature sensor is integrated into the heater & A/C control unit. The sensor contains a thermistor which measures the temperature of the inside. The signal deci ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: General Safety Information and Caution


Safety Precaution     Since electric vehicles contain high voltage batteries, mishandling the high voltage system or vehicle may lead to a serious accident, including electric shock and electric leakage.     • Be sure to shut o ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Quick-Charger Relay Assembly (QRA) Repair procedures


Removal     QRA is integrated into the high voltage joint box and so each part cannot be replaced separately. Refer to removal procedure of high voltage joint box. Installation     QRA is integrated into the high voltage joint box and so e ...

Copyright © www.ksoulev.com 2020-2025