Kia Soul EV: Parking Brake System / Electric Parking Brake (EPB) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Brake System / Parking Brake System / Electric Parking Brake (EPB) Repair procedures

Removal

1.	Turn ignition OFF and disconnect the negative (-) battery cable.

2.	Remove the floor console assembly.(Refer to Body - “Floor console assembly")

Disconnect the EPB control unit mounting nuts and then remove EPB control unit.

Tighten torque:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.	Disconnect the EPB control unit connector (A).

Installation

1.	Install in the reverse order of removal.

2.	After replacing the EPB control unit with a new one, “Variant Coding” procedure must be performed.

3.	Perform the “G-Sensor Calibration” with GDS.

4.	Check that the brake operates normally by pushing the EPB switch more than 3 times after installing the EPB module.

Variant coding

1.	Turn ignition "OFF" and connect GDS.

2.	While ignition "ON" & engine "OFF", select vehicle name and EPB system.

3.	Select EPB Variant coding mode.

4.	Perform the "EPB Variant Coding" procedure with GDS.

5.	Complete the “Variant Coding” procedure.

Electric Parking Brake (EPB) Schematic Diagrams

EPB Circuit Diagram (1) EPB Circuit Diagram (2) EPB connector input/output Pin DescriptionPin Description1WC-CAN (High)21G/BCenter Fascia Switch (ElectronicParking Brake Switch (SW3 ...

EPB Switch Repair procedures

Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console upper cover. (Refer to Body group - "Console") 3. Remove the EPB switch assemb ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Door Outside Handle Repair procedures

Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Remove the hole plug (A). 3. After loosening the mounting bolt, remove the rear door outside handle cover (B). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Remove ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Current Sensor Description and Operation

Description Battery Current Sensor is installed in the Power Relay Assembly and it measures the current when the high voltage battery is being charged or discharged. [With High Voltage Battery Heater System] 1. Main Relay (+)2. Main Relay (-)3. Pre Charge Relay4. Pre Charge Resistor5. B ...