Kia Soul EV: Hands Free System / Hands Free Switch Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Hands Free System / Hands Free Switch Repair procedures

Inspection

Check for resistance between terminals in each switch position.

[Voice + Bluetooth]

Switch	Connector terminal	Resistance (±5%)	Output voltage (± 0.22)
Voice	2-4	10.71 k?	3.5 V ± 0.22
Call off	2-4	18.91 k?	4.0 V ± 0.22
Call	2-4	40.91 k?	4.5 V ± 0.22

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the driver airbag module. (Refer to the RT group)

3.	Remove the steering wheel. (Refer to the ST group - "Steering column & shaft")

4.	Loosen the mounting screws from the rear steering wheel cover.

5.	Separate the upper steering wheel remote control switch (A) from the steering wheel. [LH] [RH]

6.	Remove the upper steering wheel control switch (B) by disconnecting the connector (A). [LH] [RH]

7.	Separate the lower steering wheel control switch (A) by loosening the mounting screws. [LH]

8.	Remove the lower steering wheel control switch (B) by disconnecting the connector (A). [LH]

Installation

1.	Install the remote control switch on the steering wheel.

2.	Install the steering wheel.

Reconnect the remote control switch connector and airbag connectors.

Make sure that the switch connector is plugged in properly.

4.	Install the driver airbag module.

5.	Connect the negative (-) battery terminal.

Hands Free Switch Schematic Diagrams

Circuit Diagram ...

Hands Free Mic Repair procedures

Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the overhead console lamp. (Refer to Body Electrical - "Overhead Console Lamp") 3. Remove the hands free mic (A) from ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Glove Box Housing Repair procedures

Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Us ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Wheel Speed Sensor Repair procedures

Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the rear wheel speed sensor. (Refer to Driveshaft and axle - "Rear Hub - Carrier") 3. Install in the reverse order of removal. ...