Kia Soul EV: Crash Pad / Crash Pad Lower Panel Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
2.
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

3.
After loosening the mounting screws, remove the crash pad lower panel (A) using a screw driver.

4.
Disconnect the diagnosis connector (A).

5.
Install in the reverse order of removal.
   
Make sure that the connectors are connected properly.
Replace any damaged clips.
Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

Glove Box Housing Components and Components Location
Component Location 1. Glove box housing ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Heater & A/C Control Unit (FATC) Repair procedures


Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display panel flickers three times every 0.5 second, the corresponding fault code flickers on the setup temperature display panel every 0.5 second and will show two figures. Codes are displayed in n ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Hood Latch Release Handle Repair procedures


Replacement 1. Using a screwdriver or remover, remove the hood release handle (A).     • Use a 6mm hex bit to press the center until the handle easily pulls off the post. 2. Install in the reverse order of removal.     • ...

Copyright © www.ksoulev.com 2020-2024