Kia Soul EV: Crash Pad / Center Fascia Panel Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Crash Pad / Center Fascia Panel Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the center fascia panel (A).

2.
Disconnect the A/C & heater controller connectors (A).

3.
Install in the reverse order of removal.
   
Make sure that the connectors are connected properly.
Replace any damaged clips.
Center Fascia Panel Components and Components Location
Component Location 1. Center fascia panel ...

Crash Pad Lower Panel Components and Components Location
Component Location 1. Crash pad lower panel ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Evaporator Temperature Sensor Repair procedures


Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminals "1" and "2" of the evaporator temperature sensor. 4. Connect the evaporator temperature sensor connector. 5. Run the engine and turn ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Pack Assembly Repair procedures


Inspection     When removing the battery pack assembly to inspect the battery system, it can be connected to vehicle by using the SST 0K918-E4100, 0K375-E4100, 0K375-E4200. Before installing the battery system assembly, check if the battery is OK by using the SST. ...

Copyright © www.ksoulev.com 2020-2024