Kia Soul EV: Blower / Blower Motor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Motor Repair procedures

Inspection
1.
Connect the battery voltage and check for the blower motor rotation.

2.
If the blower motor voltage does not operate well, substitute with a verified blower motor and check for proper operation.
3.
If the problem is corrected, replace the blower motor.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the driver shower duect (A) after loosening the mounting screw.

4.
Lower the steering column after loosening the mounting bolts.
(Refer to Steering System - "Steering Column and Shaft")
5.
Remove the fixing clip (B) after disconnecting the mode control actuator connector (A).

6.
Disconnect the temperature control connector (A).
And then remove the temperature control actuator (B) after loosening the mounting screws.

7.
Remove the brake pedal.
(Refer to Brake System - "Brake Pedal")
8.
Disconnect the blower motor connector (A).
And then remove the blower motor (B) after loosening the mounting screws.

9.
Install the reverse order of removal.
Blower Unit Repair procedures
Replacement     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failu ...

PWM Blower Module Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Repair procedures


Refrigerant System Service Basics • Since the electric compressor uses high-voltage, POE oil with high volumetric resistivity should be used. • Do not use the same A/C recovery / charging station as in conventional belt-driven compressors.     ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Seat Heater Switch Repair procedures


Removal First Row Seat 1. Remove the heater & A/C control unit. (Refer to Heating, Ventilation And Air Conditioning - "Heater & A/C Control Unit (FATC)") Second Row Seat 1. Disconnect the negative (-) battery terminal. 2. Remove the rear door trim. (Refer to Body - "Rear Door ...

Copyright © www.ksoulev.com 2020-2025