Kia Soul EV: Blower / PWM Blower Module Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Blower / PWM Blower Module Repair procedures

Inspection

1.	Turn the ignition switch OFF.

2.	Manually operate the control switch and measure the voltage of blower motor.

3.	Select the control switch to raise voltage until high speed.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Remove the glove box housing. (Refer to Body - "Glove Box Housing")

3.	Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

4.	Install in the reverse order of removal.

Blower Motor Repair procedures

Inspection 1. Connect the battery voltage and check for the blower motor rotation. 2. If the blower motor voltage does not operate well, substitute with a verified blower motor and check for p ...

Climate Control Air Filter Description and Operation

Description The climate control air filter is located in the blower unit. It eliminates foreign materials and odor. The particle filter performs a role as an odor filter as well as a conventio ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Wheel Speed Sensor Repair procedures

Removal 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the rear wheel speed sensor. (Refer to Driveshaft and axle - "Rear Hub - Carrier") 3. Install in the reverse order of removal. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Pre-Charge Registor Description and Operation

Description Pre-Charge Resistor is installed in the Power Relay Assembly (PRA) and it protects the high voltage circuit by limiting the charging current when the inverter capacitor is being pre-charged. [With High Voltage Battery Heater System] 1. Main Relay (+)2. Main Relay (-)3. Pre Cha ...