Kia Soul EV: Tire Pressure Monitoring System / TPMS Receiver Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Repair procedures

Replacement
   
When the receiver first arrives for replacement:
a.
It will be in Virgin State.
b.
It will not be configured for any specific platform.
c.
It will not have any sensor ID''s memorized.
   
It is important to make sure that the correct receiver is used to replace the faulty part i.e. it must be Low Line and not High Line in order to have the correct inflation warning thresholds set.
1.
Disconnect vehicle battery.
2.
Remove the crash pad garnish.
(Refer to BD group - "Crash Pad")
3.
Remove the receiver with bracket.

4.
Install in the reverse order of removal.
5.
Re-connect battery and turn Ignition on.
6.
After replacing the receiver, learn by using self-diagnosis device(GDS).
[Wheel Sensor ID Writing (Wireless) initialization]

[Wheel Sensor ID Writing (Wireless) 1]

[Wheel Sensor ID Writing (Wireless) 2]

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2.
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[System Identification (Wireless)]

[Sensor ID Writing (Wireless)]

[VIN input initialization]

[Vehicle name input initialization]

[Sensor Status initialization]

[Register Sensor initialization]

   
Write ID Read ID and be sure to check are the same.
After registering successfully sensor "Sensor Wireless Information" by the execution determines whether the sensor is working properly.
TPMS Receiver Description and Operation
Description 1. Mode (1) Virgin State • The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state. • In this state, there ...

Steering System
...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Power Door Lock Switch Repair procedures


Diagnosis With GDS 1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. It will be able to quickly diagnose power door lock/unlock defects with GDS. GDS can operate the actuator forcefully, monitor input ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Outer Condenser Repair procedures


Replacement     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. • Be s ...

Copyright © www.ksoulev.com 2020-2025