Kia Soul EV: Restraint / Repair procedures
Component Replacement after Deployment |
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs. |
When the front airbag(s) deployed after a collision, replace the following items.
–
|
Seat belt pretensioner(s) |
–
|
Emergency fastening device |
–
|
Inspect the clock spring for heat damage.
If any damage is found, replace the clock spring.
|
When the side/curtain airbag(s) deployed after a collision, replace the following items.
–
|
Side impact sensor(s) on the deployed side(s) |
When the vehicle is completely repaired, verify that the SRS airbag system is OK.
–
|
When the ignition switch is turned ON, the SRS indicator should come on for about 6 seconds before going off. |
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag system service.
Carefully observe the instructions described in this manual
as mis ...
Other information:
High Voltage Shut-off Procedure
Be sure to read and follow the “General Safety Information
and Caution” before doing any work related with the high voltage
system. Failure to follow the safety instructions may result in serious
electrical injuries.
...
Description
Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This supplemental system shows the back of the vehicle on the monitor when the vehicle is backing up.
This system is a supplment ...