Other information:
Inspection
1.
Measure the pressure of high pressure line by measuring voltage output between terminals No. 1 and No. 2.
2.
Inspect the voltage value whether it is within the specified range.
Voltage = 0.00878835 * Pressure + 0.5[PSIA]
3.
If the measured voltage value is not within t ...
Description
RAD is installed on each battery module.
If the high voltage battery is swollen by cell overcharge, RAD cuts the ground of the main relay and the pre-charge relay.
If the cell is overcharged, the switch turns OFF and the vehicle cannot be driven.
RAD
RAD on 10 cells
RAD on ...