Kia Soul EV: Rear Door / Rear Door Window Glass Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Window Glass Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).

3.
Hold down the power window glass switch to pull down the rear door window glass to the maximum level.
4.
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).

5.
After loosening the mounting screws, remove the rear door delta garnish (A).

6.
Completely loosen the rear door channel mounting bolt and loosen the nuts as much as possible until they are just enough to hold the rear door panel.
7.
Slightly push the rear door channel in the direction of the arrow in the illustration below.

8.
Remove the rear door window glass mounting hole plug (A).

   
Be careful not to drop the glass and/or scratch the glass surface.
   
Use the door switch to align the mounting hole/bolt with the hole in the door.
If unable to operate the window motor, remove the motor and align the hole by hand.
9.
Carefully adjust the rear door window glass (A) until you can see the bolt, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

10.
Install in the reverse order of removal.
   
Roll the glass up and down to see if it moves freely without binding.
Adjust glass position as needed.
Make sure that the door locks and opens properly.
Replace any damaged clips.
Rear Door Window Glass Components and Components Location
Component Location 1. Rear door window glass ...

Rear Door Module Components and Components Location
Component Location 1. Rear door module ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Power Electric Frame Repair procedures


Removal 1. Remove the motor & gear drive unit. (Refer to Traction Motor System - "Motor & Gear Differential Unit Assembly") 2. Remove the Electric Water Pump (EWP). (Refer to Traction Motor System - "Electric Water Pump") 3. Remove the accumulator mounting bolt (A). Tighteni ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Pressure Source Unit Repair procedures


Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the brake fluid level switch connector (A), and remove the reservoir cap.     Be sure to completely remove foreign substances around brake fluid reservoir and cap be ...

Copyright © www.ksoulev.com 2020-2025