Kia Soul EV: Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the rear bumper cover. (Refer to Rear Bumper - "Rear Bumper Cover")

2.	Disconnect the bumper antenna connector (A) and license lamp connector (B).

3.	Remove the joint connector mounting clip (C).

4.	Remove the rear bumper wiring harness mounting clips (A).

5.	Remove the mounting clips (B) and the rear bumper beam assembly (C), and then loosen the clips.

Install in the reverse order of removal.

•	Make sure that the connectors are plugged in properly.

•	Replace any damaged clips.

Rear Bumper Beam Assembly Components and Components Location

Component Location 1. Rear bumper beam assembly ...

Rear Door

...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Receiver-Drier Repair procedures

Replacement [Without Heat Pump] 1. Remove the condenser, and then use an L wrench to remove the bottom cap (B) from the condenser. Tightening torque : 9.8 ~ 14.9 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft) 2. Remove the desiccant (A) from the condenser using a long nose plier. Che ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: High Voltage Shut-off Procedures

High Voltage Shut-off Procedure Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. ...