Kia Soul EV: Power Door Locks / Power Door Lock Switch Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Power Door Locks / Power Door Lock Switch Repair procedures

Diagnosis With GDS

1.	The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. It will be able to quickly diagnose power door lock/unlock defects with GDS. GDS can operate the actuator forcefully, monitor input/output values and self diagnose.

2.	To diagnose the SJB function, select the vehicle model, BCM and DDM.

3.	Select "Input/output monitoring" if you wish to check the current data of power door lock system. This menu provides input/output status of DDM.

4.	To perform functional test on SJB outputs, select "Actuation Test".

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim. (Refer to Body - "Front Door Trim")

3.	Remove the power window switch assembly (A) by loosening the mounting screws (8EA).

4.	Remove the power window switch (A) after loosening the mounting screws (4EA).

Installation

1.	Install the power window switch assembly.

2.	Install the front door trim after connecting the connector.

Power Door Lock Actuators Repair procedures

Inspection Front Door Lock Module Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Remove the front door module. (Refer to Body - "Front Door Module") 3. ...

Power Door Mirrors

...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: High Voltage Shut-off Procedures

High Voltage Shut-off Procedure Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Management System (BMS) ECU Schematic Diagrams

System Circuit Diagram Connector Location BMS ECU Connector And Terminal Function BMS ECU Terminal Function A Connector [B01-A] (35 Pin) - Voltage Measurement Connector Pin no.DescriptionConnected to1Battery Cell [Module 8/Cell 13] Voltage InputBattery Cell [Module 8/Cell 13]2Battery Cell ...