Kia Soul EV: Blower / Intake Actuator Description and Operation
The intake actuator is located in the blower unit. It
regulates the intake door by signal from control unit. Pressing the
intake selection switch will shift between recirculation and fresh air
modes.
Replacement
1.
Open the glove box (A).
2.
Remove the air filter panel (A).
3.
Remove the filter cover (A) by pressing the filter cover knob.
4.
Replace the air filter (A) with a new on ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the actuator operates to the recirculation position when 12V is connected to termina ...
Other information:
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher intensive light and reduce with lower intensive light.
1. Auto Light Signal2. Auto ...
Replacement
[Without Heat Pump]
1.
Remove the condenser, and then use an L wrench to remove the bottom cap (B) from the condenser.
Tightening torque :
9.8 ~ 14.9 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)
2.
Remove the desiccant (A) from the condenser using a long
nose plier. Che ...