Kia Soul EV: Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Seat Belt / Front Seat Belt Pretensioner Repair procedures

Replacement
   
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
After loosening the mounting bolt, remove the front seat belt upper anchor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After disconnecting the pretensioner connector lock pin, remove the front seat belt pretensioner connector (A), loosen the mounting bolt, and then remove the front seat belt pretensioner (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure that the connectors are plugged in properly.
Replace any damaged clips.
Front Seat Belt Pretensioner Components and Components Location
Component Location 1. Front seat belt pretensioner ...

Height Adjust Components and Components Location
Component Location 1. Height adjust ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Rear Hub - Carrier Repair procedures


Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 3. Loosen the guide rod bolt (B) and the remove ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Heater Unit Components and Components Location


Component Location 1. Heater unit Components [LH] 1. Floor shower duct assembly [LH]2. Duct sensor3. Interior condenser cover4. Heater core cover5. Temp door arm6. Temp door lever7. Temp actuator motor assembly8. Floor door lever9. Mode actuator motor assembly [LH]10. Mode cam11. Motor ...

Copyright © www.ksoulev.com 2020-2025