Kia Soul EV Manuals

Kia Soul EV: Floor Carpet / Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Floor Carpet / Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove both sides of front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
4.
Remove both sides of center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
5.
Remove both sides of cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
6.
Remove both sides of luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
7.
Remove the safety plug cover (A).
8.
Remove the floor carpet assembly (B).
9.
Remove the rear tunnel pad (B).
10.
Install in the reverse order of removal.
   
•
Replace any damaged clips.

1. Floor carpet assembly
2. Rear tunnel pad
3. High voltage safety plug cover

Floor Carpet
...

Floor Console
...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Pre-Charge Registor Description and Operation


Description Pre-Charge Resistor is installed in the Power Relay Assembly (PRA) and it protects the high voltage circuit by limiting the charging current when the inverter capacitor is being pre-charged. [With High Voltage Battery Heater System] 1. Main Relay (+)2. Main Relay (-)3. Pre Cha ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Smart Key Repair procedures


Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn''t flicker. Standard voltage : 3V 3. Insert the battery (A) into the tester (09954-2P100). 4. Pus ...

Copyright © www.ksoulev.com 2020-2023