Kia Soul EV: Front Door / Front Door Window Glass Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Window Glass Repair procedures

Replacement
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Remove the front door belt inside weatherstrip (A).

3.
Remove the front door window glass mounting hole plug (A).

4.
Before removing the front door glass (C), loosen the mounting bolt (A) as loosely as possible and loosen the mounting bolt (B) completely.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

   
Be careful not to drop the glass and/or scratch the glass surface.
   
Use the door switch to align the mounting hole/bolt with the hole in the door.
If unable to operate the window motor, remove the motor and align the hole by hand.
5.
Carefully adjust the front door window glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
   
When removing the front door glass, be careful not to separate the glass mounting bracket (B).

6.
Install in the reverse order of removal.
   
Roll the glass up and down to see if it moves freely without binding.
Adjust glass position as needed.
Make sure that the door locks and opens properly.
Replace any damaged clips.
Front Door Window Glass Components and Components Location
Component Location 1. Front door window glass ...

Front Door Module Components and Components Location
Component Location 1. Front door module ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Photo Sensor Description and Operation


Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation rece ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Steering Gear box Repair procedures


Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Loosen the bolt and then disconnect the universal joint assembly (A) from the pinion of the steering gear box. Tightening torque : 32.4 ~ 37.3N.m (3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb- ...

Copyright © www.ksoulev.com 2020-2023