Kia Soul EV: Front Door / Front Door Trim Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Trim Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Be careful not to scratch the door trim and other parts.

1.	Using a screwdriver or remover, remove the front door quadrant inner cover (A).

2.	Using a flat-tip screwdriver (A), remove the front door inside handle cap (B) and front door pull cap (C).

3.	After loosening the mounting screws, remove the front door trim (A) using a flat-tip screwdriver (B).

4.	Remove the front door inside handle cage (A).

5.	Disconnect the outside rear view mirror switch connector (A) and power window switch connector (B).

Install in the reverse order of removal.

•	Make sure that the connectors are connected properly.

•	Make sure that the door locks/unlocks and opens/closes properly.

•	Replace any damaged clips.

Front Door Trim Components and Components Location

Component Location 1. Front door trim ...

Front Door Inside Handle Repair procedures

Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Loosen the front door inside handle mounting screws (A). 3. Using a flat-tip screwdriver (B), pull ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Inner Condenser Repair procedures

Replacement • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries. • Be s ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Temperature Control Actuator Repair procedures

Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the cool position when 12V is connected to terminal 3 and ground to terminal 7. Verify that the temperature control actua ...