Inspection
1.
Check the condenser fins for clogging and damage. If clogged,
clean them with water, and blow them with compressed air. If bent,
gently bend them using a screwdriver or pliers.
...
Inspection
1. Vcc2. Ground
Check the voltage between terminals 6 and 7.
1.
Using the tester, check the resistance between terminals 1 and 2.
TemperatureResistance°C°FSpecification [K?]Tolerance [%]-40-40225.1± 3.06-30-22129.3± 2.49-20-476.96± 1.95-101447.34± 1.4603230± 1.00 ...
Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.
Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)
2.
Completely open ...