Kia Soul EV: Charge Door Opener Cover / Charge Door Opener Actuator Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Charge Door Opener Cover / Charge Door Opener Actuator Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

3.	Remove the charge door opener cover assembly. (Refer to Body - "Charge Door Opener Cover")

4.	Remove the charge door opener actuator cable (A).

5.	Remove the charge door opener actuator (C) after loosening the mounting bolts (A) and screws (B).

Installation

1.	Install the charge door opener actuator and cable.

2.	Install the charge door opener cover assembly on the front bumper cover.

3.	Install the front bumper cover.

4.	Connect the negative (-) battery terminal.

Inspection

1.	Remove the connector from the charge door opener actuator.

2.	Connect battery positive (+) and negative (-) cables to terminals 1 and 2 respectively.

3.	Check that the motor operates normally. Replace the motor if it operates abnormally.

Components and Components Location

Components Location 1. Charge door opener actuator switch2. Charge door opener actuator3. Charge door opener cover ...

Charge Door Opener Actuator Switch Components and Components Location

Components ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Components and Components Location

Components 1. Front seat headrest2. Front seat headrest guide3. Front seat back cover4. Front seat back heater5. Front seat back pad6. Front seat back lumbar assembly7. Front seat back frame assembly8. Front seat back board9. Front seat cushion cover10. Front seat cushion heater11. Front seat c ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Power Window Switch Repair procedures

Inspection Power Window Main Switch Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refer to Body - "Front Door Trim") 3. Disconnect the connector (A) from the power window switch module. 4. Check for continuity between the terminals in e ...