When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
2.
Remove the rear door scuff trim.
(Refer to Interior Trim - "Door Scuff Trim")
3.
Carefully remove the front door body side weatherstrip.
4.
Carefully remove the rear door body side weatherstrip.
5.
Remove the center pillar lower trim.
(1)
To remove the seat belt anchor pretensioner (C), keep pushing
the lock pin (A) in the direction of the arrow. Then, push in the lock
pin (B) and remove the seat belt.
(2)
Using a screwdriver or remover, remove the center pillar lower trim (A).
6.
Install in the reverse order of removal.
•
Replace any damaged clips.
[Center pillar upper trim]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the center pillar lower trim.
2.
After loosening the mounting bolt, remove the center pillar upper trim (A).
Inspection
In the state of IGN1 ON, when the multi function switch
module detects auto light switch on, tail lamp relay output and head
lamp low relay output are controlled according to auto light sensor''s
input.
During IGN1 ON, the BCM monitors the range of this supply and
alerts the f ...
Center Pillar Trim Components and Components Location
Rear Transverse Trim Components and Components Location