Kia Soul EV: Seat Electrical / Air Ventilation Seat Control Unit Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Seat Electrical / Air Ventilation Seat Control Unit Repair procedures

Removal

Cushion Blower

1.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

2.	Remove the cushion blower (B) after loosening the screws and disconnecting the connector (A).

Back Blower

1.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

2.	Remove the front seat back cover. (Refer to Body - "Front Seat Back Cover")

3.	Disconnect the connector (A) and fasteners (B).

4.	Remove the back blower (A) after loosening the mounting screws.

Air Ventilation Unit

1.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

2.	Remove the air ventilation unit (A) after loosening the screws and disconnecting the connector. [Drive''s Side] [Passenger''s Side]

Installation

Cushion Blower

1.	Install the cushion blower.

2.	Install the front seat assembly.

Back Blower

1.	Install the back blower.

2.	Install the front seat back cover.

3.	Install the front seat assembly.

Air Ventilation Unit

1.	Install the air ventilation unit.

2.	Install the front seat assembly.

Air Ventilation Seat Control Unit Description and Operation

Description The ventilated seat system generates cool wind by the Push method in the blower mounted under the seat which then travels through ducts to the seat back and cushion. &n ...

Smart Key System

...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Refrigerant Direction Control Valve Repair procedures

Inspection 1. Vcc2. Ground Check the voltage between terminals 6 and 7. 1. Using the tester, check the resistance between terminals 1 and 2. TemperatureResistance [K?]°C°F-30-228.7~9.5-25-138.92~9.74-20-49.14~9.98-1559.37~10.23-10149.59~10.47-5239.81~10.7103210.03~10.9554110.25~11.191 ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Electric Parking Brake (EPB) Repair procedures

Removal 1. Turn ignition OFF and disconnect the negative (-) battery cable. 2. Remove the floor console assembly.(Refer to Body - “Floor console assembly") 3. Disconnect the EPB control unit mounting nuts and then remove EPB control unit. Tighten torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 ...