Recover the refrigerant with a recovery/ recycling/ charging station.
•
Do not use the same A/C recovery / charging station as conventional belt-driven compressors.
•
Since the electric compressor uses high-voltage, POE oil with high resistivity should be used.
•
If PAG oil mixes into the POE oil of the system, dielectric
breakdown may occur due to decreased volumetric resistivity and the A/C
compressor may not work.
2.
Disconnect the negative (-) battery terminal.
3.
Remove the refrigerant line after loosening the mounting nuts (A).
4.
Remove the accumulator (A) after loosening the mounting bolt.
5.
Install in the reverse order of removal.
•
Do not use the same A/C recovery / charging station as conventional belt-driven compressors.
•
Since the electric compressor uses high-voltage, POE oil with high resistivity should be used.
•
If PAG oil mixes into the POE oil of the system, dielectric
breakdown may occur due to decreased volumetric resistivity and the A/C
compressor may not work.
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before starting work.
The support rod must be inserted into the hole near the edge
of the hood whenever you inspect the engine compartment to prevent the ...