Kia Soul EV: Seat Electrical / Seat Heater Switch Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Repair procedures

Removal
First Row Seat
1.
Remove the heater & A/C control unit.
(Refer to Heating, Ventilation And Air Conditioning - "Heater & A/C Control Unit (FATC)")
Second Row Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
3.
Remove the power window switch assembly (A) by loosening the mounting screws (7EA).

Installation
First Row Seat
1.
Install the heater & A/C control unit.
(Refer to Heating, Ventilation And Air Conditioning - "Heater & A/C Control Unit (FATC)")
Second Row Seat
1.
Install the power window switch.
2.
Install the rear door trim.
3.
Connect the negative (-) battery terminal.
Inspection
First Row Seat
1.
Disconnect the negative (-) batttery terminal.
2.
Disconnect the A/C & heater controller connectors (A).
(Refer to Heating, Ventilation And Air Conditioning - "Heater & A/C Control Unit (FATC)")

3.
Operate switch and check for continuity between the terminals.
If there is no continuity, replace the seat heater switch.

Second Row Seat
1.
Disconnect the negative (-) batttery terminal.
2.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
3.
Operate driver seat heater switch and check for continuity between the terminals.
If there is no continuity, replace the seat heater switch.

Seat Heater Switch Schematic Diagrams
Circuit Diagram [First Row Seat] Second Row Seat ...

Seat Heater (Non-Air Ventilation) Components and Components Location
Components ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Hood Latch Components and Components Location


Component Location 1. Hood lower latch assembly ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Pre-Charge Registor Description and Operation


Description Pre-Charge Resistor is installed in the Power Relay Assembly (PRA) and it protects the high voltage circuit by limiting the charging current when the inverter capacitor is being pre-charged. [With High Voltage Battery Heater System] 1. Main Relay (+)2. Main Relay (-)3. Pre Cha ...

Copyright © www.ksoulev.com 2020-2025