Kia Soul EV: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement
   
When installing the belt, be careful not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
2.
Loosen the rear seat belt upper anchor (A) mounting bolt.
3.
After loosening the mounting bolt, remove the rear seat belt retractor (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure that the connectors are plugged in properly.
Replace any damaged clips.
Rear Seat Belt Retractor Components and Components Location
Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and Components Location
Component Location 1. Rear center seat belt retractor ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Refrigerant line Components and Components Location


Component Location [Without Heat Pump] 1. Refrigerant line [With Heat Pump] 1. Refrigerant line ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Management System (BMS) ECU Repair procedures


Inspection C-CAN Terminating Resistance Inspection (Multi Purpose Check Connector) 1. Turn the ignition OFF. 2. Measure the resistance between pins No. 20 and No. 17 of multi purpose check connector (20 pins). Measure the resistance between pins No. 3 and No. 11 of DLC (16 pins). Spec ...

Copyright © www.ksoulev.com 2020-2025