Kia Soul EV: Floor Console / Rear Console Cover Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Floor Console / Rear Console Cover Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
2.
Loosen the rear console cover mounting screws (A).

3.
Using a screwdriver or remover, remove the rear console cover (A).

4.
Install in the reverse order of removal.
   
Make sure that the connectors are plugged in properly.
Replace any damaged clips.
Rear Console Cover Components and Components Location
Component Location 1. Rear console cover ...

Console Armrest Components and Components Location
Component Location 1. Console armrest ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: General Information


Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate that particular materials should be applied in each part during the sevice. SymbolMeaningDo not reuse the part. Replace a new one.Apply engine oil or transmission oil to the part. ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Battery Management System (BMS) ECU Schematic Diagrams


System Circuit Diagram Connector Location BMS ECU Connector And Terminal Function BMS ECU Terminal Function A Connector [B01-A] (35 Pin) - Voltage Measurement Connector Pin no.DescriptionConnected to1Battery Cell [Module 8/Cell 13] Voltage InputBattery Cell [Module 8/Cell 13]2Battery Cell ...

Copyright © www.ksoulev.com 2020-2023