Kia Soul EV: Power Windows / Power Window Motor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Power Windows / Power Window Motor Repair procedures

Inspection
Front Power Window Motor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the connector (A) from the motor.
(A : Safety, B : Standard)

4.
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.
[General Window Motor]

5.
Connect the terminals No. 2 and No. 3 to battery voltage (12V) and check that the motor operates smoothly when connected to the following terminals.
[Safety Window Motor]

Rear Power Window Motor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
3.
Disconnect the connector (A) from the motor.

4.
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

Power Window Motor Components and Components Location
Components ...

Power Window Switch Components and Components Location
Components Driver Power Window Switch Assist Power Window Switch Rear Power Window Switch ...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Side Impact Sensor (SIS) Repair procedures


Removal Pressure Side Impact Sensor     • Removal of the airbag must be performed according to the precautions / procedures described previously. • Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s). ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Cooling Fan Repair procedures


Inspection 1. Turn the ignition switch OFF and disconnect the auxiliary battery (12V) negative (-) terminal. 2. Connect the GDS to DLC. 3. Turn the ignition switch ON. 4. Inspect "Control Duty" and waveforms according to "Fan Status" by performing "Actuation Test" on GDS. Cooling ...

Copyright © www.ksoulev.com 2020-2021