Kia Soul EV Manuals

Kia Soul EV: Front Suspension System / Power Electric Frame Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Suspension System / Front Suspension System / Power Electric Frame Repair procedures

Removal
1.
Remove the motor & gear drive unit.
(Refer to Traction Motor System - "Motor & Gear Differential Unit Assembly")
2.
Remove the Electric Water Pump (EWP).
(Refer to Traction Motor System - "Electric Water Pump")
3.
Remove the accumulator mounting bolt (A).
Tightening torque :
6.8 ~ 10.7 N.m(0.7 ~ 1.1 kgf.m, 5.0 ~ 7.9 lb-ft)

4.
Remove the wiring (A) from the power electric frame.

5.
Remove the LH & RH support bracket mounting nut (A,B) and then remove the Power Electric Frame (A).
Tightening torque
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
78.5 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.9 ~ 72.3 lb-ft)

6.
Install in the reverse order of removal.
Sub Frame Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Loosen the bolt (A) and then disconnect the universal joint assembly from the pin ...

Rear Suspension System
...

Other information:

Kia Soul EV (PS EV) 2015-2020 Service Manual: Panorama Sunroof Assembly Repair procedures


Removal     • In order to remove the panorama sunroof assembly, use the tools shown in the following figure: [Tooling Diagram] Square wire Insert-type wire grip [Tooling Assembly Diagram] • Insert and affix square wire into the insert hole of ...

Kia Soul EV (PS EV) 2015-2020 Service Manual: Blower Unit Components and Components Location


Component Location 1. Blower unit Components 1. High voltage PTC heater core2. Ionizer3. Evaporator temperature sensor4. Air inlet filter cover assembly5. Heater core pipe mounting bracket6. Heater - evaporator seal7. Intake duct case [LH]8. Intake arm9. Intake actuator motor assembly10. ...

Copyright © www.ksoulev.com 2020-2025